M 29F800FB - 55N3E2 NUX

Product Overview

IC Picture

Images are for reference only

Manufacturer Part No M 29F800FB - 55N3E2 NUX
Brand MICRON
Item FLASH-NOR
Part No 29F800 BOTTOM

Product Details

Package TSOP-48
Outpack
RoHS RoHS
Voltage 5.0 V
Temperature -40 C~+125 C
Speed 55 NS
Std. Pack Qty
Std. Carton

Description The following overview of the Numonyx® Axcell™ M29F 5 V Flash Memory device (M29W160F) refers to the 16-Mbit device. However, the information can also apply to lower densities of the M29F device. The M29F160F is a 16 Mbit (2 Mbit x8 or 1 Mbit x16) non-volatile memory that can be read, erased and reprogrammed. These operations can be performed using a single low voltage (4.5 to 5.5 V) supply. On power-up the memory defaults to its Read mode where it can be read in the same way as a ROM or EPROM. The memory is divided into blocks that can be erased independently so it is possible to preserve valid data while old data is erased. Each block can be protected independently to prevent accidental Program or Erase commands from modifying the memory. Program and Erase commands are written to the Command Interface of the memory. An on-chip Program/Erase Controller simplifies the process of programming or erasing the memory by taking care of all of the special operations that are required to update the memory contents. The end of a program or erase operation can be detected and any error conditions identified. The command set required to control the memory is consistent with JEDEC standards. The blocks in the memory are asymmetrically arranged, as shown in Figure 10.: Block Addresses, M29F160 (x8) and Figure 11.: Block Addresses, M29F160 (x16). The first or last 64 KBytes have been divided into four additional blocks. The 16 KByte Boot Block can be used for small initialization code to start the microprocessor, the two 8 KByte Parameter Blocks can be used for parameter storage and the remaining 32K is a small Main Block where the application may be stored. Chip Enable, Output Enable and Write Enable signals control the bus operation of the memory. They allow simple connection to most microprocessors, often without additional logic. The memory is offered in TSOP48 (12 x 20mm), SO44 , and TFBGA48 (0.8 mm pitch) packages. The memory is supplied with all the bits erased (set to ’1’).

Available Offers

Description Qty Datecode
M 29F800FB - 55N3E2 NUX 35 Get Quote

FFFE (Form, Fit & Functional Equivalents)

Description Package Voltage Speed Temperature
M29F800DB 55 N 3 TSOP-48 5.0 V 55 NS -40 C~+125 C
M29F800FB55N3 TSOP-48 5.0 V 55 NS -40 C~+125 C
M29F800FB55N3E2 TSOP-48 5.0 V 55 NS -40 C~+125 C
M29F800FB55N3F2 TSOP-48 5.0 V 55 NS -40 C~+125 C